Rimage DL5200 Replacement Procedure page 3

0BReplace a Recorder on a Rimage DiscLab System
a. Remove the front panel from the system by
pulling outward.
b. Pull the recorder out of the front of the system.
Install the Recorder
1. Slide the new recorder into the system.
2. Position the recorder so that the face of the recorder is flush with the edge of the frame.
3. Insert and partially tighten the Allen screws (Qty. 2
per side, 4 total) on both sides of the recorder.
Important! Do not tighten the screws
completely. You should still be able to move
the recorder slightly.
2000122_D
DiscLab™, DL5200™ and DLN5200™
Front
Panel
© 2008, Rimage Corporation 3