4. Format cache drives as Basic Disk with NTFS. 5. Power off the PC. Remove tape. Printer Preparation Follow directions from the Everest Unpacking and Setup Instructions found with the Everest Printer. Then return to this page. Remove tape. Install supply bin. Page 1...
Page 2
Install Printer and Connect Cables Place printer on autoloader. Connect the other end of the round cable to the printer. Connect the round cable to the autoloader with the key facing to the left. to the left. 110752-000 Connect power Connect USB cable to printer.
Page 3
Complete Cabling Connections Connect the FireWire to the autoloader. Connect the FireWire to the PC. Connect the AC power cord to the autoloader and wall outlet. 110752-000 Page 3...
Power on the autoloader before powering on the PC. Place the Software Suite disc in CD-ROM drive and close drawer. If the Rimage Producer Software installation starts, Cancel the process. 110752-000 When the “Found New Hardware Wizard” displays, select Cancel.
Page 5
Install Producer Software Suite Select Run from the Windows menu. 110752-000 Browse to select Setup.exe from the CD-ROM drive. D:\Setup.exe Answer prompts to complete software installation. Go to the Software Getting Started Guide to record your first disc. Page 5...