30 What To Do If Something Goes Wrong; When The "Wait" Indicator Is Lit - Ricoh FW870 Operating Instructions Manual

You cannot start copying while the "Wait" indicator is lit.
Check indicators on the operation panel and take action according to the
instructions shown below.
S If no indicator is lit on the operation panel, check that the power is on.
Indication
x is lit.
A is lit.
C is lit.
D is lit or blinking.
E is lit or blinking.
M is lit.
L is lit.
u is lit.

30 WHAT TO DO IF SOMETHING GOES WRONG

WHEN THE "WAIT" INDICATOR IS LIT

Corrective action
Remove the misfed paper. → See page 35.
Remove the misfed original. → See page 34.
Load paper in the roll feeder. → See page 38.
Add toner. → See page 43.
The toner bottle is filled with used toner. Contact your
service representative.
Any cover is open at the roll feeder or other unit of the
copier.
Close the cover.
Something goes wrong with the copier. Contact your
service representative.
The paper cut length indicator displays alphabetical
characters or numerals. You should also inform the
service representative of these values.
Set the key counter.