Ricoh CL3500N Maintenance Manual page 75

Troubleshooting
Messages
Change Setting
Tray #
/ Paper Size:
Paper Type:
Close Front and/
or Right Cover
Close Upper Left
Cover
DHCP assigned
Cannot change
Energy Save Mode
Error: Enter 10
or 26 characters
Error: Enter 5
or 13 characters
Hardware Problem
Ethernet
Hardware Problem
HDD
Description
The paper size and type set-
ting in the tray differs from that
of actual paper size and type in
the tray.
The front cover or right cover is
open.
The upper left cover open.
An attempt to change the IP
address, subnet mask or gate-
way address was made while
DHCP was set to [On].
In Energy Save Mode level 2.
An ID with an invalid number of
digits was entered for the WEP
key.
An ID with an invalid number of
digits was entered for the WEP
key.
The printer identified an Ether-
net error.
The printer identified a HDD
Board error.
Recommended Action
Load paper of the selected
size in the tray, and then
change the paper size setting
with the control panel. Or,
press {Form Feed}, and then
select the tray using the con-
trol panel. Or, press {Job Re-
set} to cancel the print job.
Close the front cover or right
cover.
Close the upper left cover.
Make the change after setting
DHCP to [Off].
No action required.
Enter the correct number of
digits for the WEP key.
Enter the correct number of
digits for the WEP key.
Turn the power off, and then
on. If the message appears
again, contact your sales or
service representative.
Turn the power off, and then
on. Remove and re-install the
HDD board correctly. If the
message appears again, con-
tact your sales or service rep-
resentative.
See "Attaching Printer Hard
Disk Type 3000", Setup
Guide.
75