Mac Os - Installing The Postscript 3 Printer Driver - Ricoh AP400 Setup Manual

❖ ❖ ❖ ❖ When connecting with USB
The printer must be connected to the USB connector of a computer using the
USB interface cable.
- Cautions when connecting the USB interface cable and the IEEE -
- -
1394 interface cable
Limitation
❒ Do not unplug the cable while printing. Do not turn off the printer power
while printing or during bidirectional transmission.

Mac OS - Installing the PostScript 3 Printer Driver

Preparation
If the AdobePS installation starts under Mac OS X, the desktop automatically
changes to the Classic environment. If you want to set a printer with Mac OS
X, see p.76 "Mac OS X - Installing the PostScript 3 Printer Driver".
This section describes how to configure Mac OS to use EtherTalk and USB. The
following procedure describes how to configure Mac OS 9.1. If you are not using
Mac OS 9.1, see the manual that comes with your version of the Mac OS for more
information.
Limitation
❒ For use with Mac OS 8.6 or later. (Mac OS X Classic environment is support-
ed.)
❒ For use with a Macintosh, Power PC is required.
Note
❒ The PostScript 3 printer driver is stored in the following folder on the CD-
ROM:
Mac OS 8 and 9:PS Driver:(language):Disk1
A A A A
Insert the CD-ROM into the CD-ROM drive.
B B B B
Double-click the CD-ROM icon.
C C C C
Double-click the [Mac OS 8 and 9] folder.
D D D D
Double-click the [PS Driver] folder.
E E E E
Double-click the folder of the language you are using.
F F F F
Open [DISK1], and then double-click the installer icon.
Installing the PostScript Printer Driver
4
73