Page 1
TRUE INDUCTION TI-1G & TI-2G GAS COMBO COOKTOP MANUAL TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 2
Trouble Shooting EXPERIENCE THE DIFFERENCE WITH INDUCTION Thank you for purchasing a True Induction TI-1G & TI-2G Gas Combo cooktop. Please read the entire instruction manual prior to using your unit. If you have any questions regarding the True Induction cooktop please visit http://www.Truelnduction.com...
Page 3
WARNING: Gas leaks cannot always be detected by smell. Gas suppliers recommend that you use a gas detector approved by UL or CSA. If a gas leak is detected, follow the “What to do if smell gas” instructions above. TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 4
Storage on the cooktop – Flammable materials should not be stored on or near surface units. Top burner flame size should be adjusted so it does not extend beyond the edge of the cooking utensil. TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 5
The appliance must be isolated from the gas supply piping system by closing its individual man- ual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5 kPa). SAVE THESE INSTRUCTIONS TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 6
6. Raise Power Key 7. Time Control Key 8. Temperature Key 9. Heat Key 10. Power Button 11. Left Control Knob 12. Right Control Knob 13. Left Gas Burner 14. Right Gas Burner TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 7
installed at least 2 inches from the wall. There must be a distance of at least 26 inches between the cooktop and any wall cupboard or extractor hood positioned immediately above. TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 8
Cut a rectangle hole in the countertop where the cooktop is to be placed. The dimensions for the TI-1G are 14 1/4’’ x 23 3/4’’, and the TI-2G are 19 1/2’’ x 22’’. Please use the “Cut Out Board” includ- ed in the box.
Page 9
185°F (85°C) above the ambient/room temperature which ranges 68°F (20°C) to 77°F (25°C). However certain types of vinyl or laminate kitchen furniture are particular- ly prone to heat damage or discoloration at temperatures below 185°F (85°C). TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 10
Position the cooktop in the recess and secure by means of the brackets as shown in fig.15 (for 1 3/16’’ or 1 37/64’’ thick work top). See next page for illustrations. TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 11
For proper operation, the pressure supplied must be between 10” and 13” of water column. When checking for proper operation of this regulator, the inlet pressure must be at least 1” greater than the operating pressure as given above. TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 12
Leak test REPLACEMENT OF THE BURNER INJECTORS Remove the gratings and the burner covers; Using a wrench, substitute the nozzle injectors; “J” (Fig.20) with the pair provided in the small bag. TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 13
Install a manual gas line shut-off valve in the gas line in an easily accessed location outside of the range. Make sure everyone operating the range knows where and how to shut off the gas supply to the cooktop. TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 14
HI and LOW positions, and never between the HI and OFF position. When the range is not being used, set the gas knobs to their OFF positions and also close the gas shut-off valve placed on the main gas supply line. TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 15
A smaller diameter pot or pan placed on a larger burner does not necessarily mean an increased rate in boiling conditions. Burner Pan Diameter Auxiliary 3.2’’ to 5.5’’ Semi-Rapid 5.5’’ to 7.8’’ Rapid 7.8’’ to 11’’ Triple Ring Above 10.2’’ TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 16
IIII. How To Use The Cooktop Continued... Compatible Cookware for Gas Burners TI-1G TI-2G 1. Auxiliary Gas Burners 2. Semi-rapid burner 3. Control Knob 4. Flame Out Safety Device 5. Thermocouple TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 17
It’s very important to check that the burner flame distributor F and the cap C are correctly repo- sitioned. Failure to do so can cause serious problems. Also check the electrode S & Thermocou- ple are clean to ensure trouble-free sparking. TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 18
The triple ring burner must be correctly positioned (seen fig.7); the burner rib must be entering in their ligament as shown by the arrow. The burner correctly positioned must not be able to rotate (fig.8). Then position the cap A and the ring B (fig.8). TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...
Page 19
The cookware is not stable. The bottom of the cookware is perfectly flat. The cookware is centered correctly on the burner or electric hot plate. The support grids have not been inverted. TI-1G & TI-2G GAS COMBO COOKTOP MANUAL...