Page Separation And Length Reduction; Tsi Print (Transmitting Subscriber Identification Print); When There Is No Paper Of The Correct Size - Ricoh Aficio 1515 Facsimile Reference Manual

Reception Features
Page Separation and Length
Reduction
When the size of a received message
is longer than the paper loaded in the
machine, each page of the message
can be split and printed on several
sheets, or reduced and printed on a
single sheet. For example, this func-
tion splits the message if the message
length is 20 mm (0.79") or longer than
the paper used. The message is re-
duced if it is less than 20 mm (0.79").
4
When a message is split, an asterisk
(*) is inserted at the split position and
about 10 mm (0.39") of the split area is
duplicated on the top of the second
sheet.
Nd1x01e1.eps
Note
Your service representative can
customize this function with the
following settings:
• Reduction
• Print split mark
• Overprinting
• Overprinting length
• Guideline for split
You can adjust the overprinting
and reduction lengths within the
following ranges:
• Overprinting length: 4 mm (0.16"),
10 mm (0.39"), 15 mm (0.59")
• Guideline for split: 5-155 mm (5
mm steps)/0.2"-6.1" (0.2" steps)
42
TSI Print (Transmitting
Subscriber Identification Print)
Usually the sender's Fax Header is
printed on received messages. If the
sender has not programmed their Fax
Header, you will not be able to identi-
fy them. However, if you turn this
function on, the sender's Own Name
or Own Fax Number is printed in-
stead so you can find out where the
message came from. When you re-
ceive an Internet Fax, the e-mail ad-
dress of the sender is printed.
Reference
p.57 "Initial Settings and Adjust-
ments", Facsimile Reference <Basic
Features>
Note
You can turn this function on or off
in the User Parameters. See p.76
"User Parameters" (switch 02, bit
3).
When There Is No Paper of the
Correct Size
If there is no paper in your machine
that matches the size of a received
message, the machine chooses a pa-
per size based upon the paper you
have available. For example, if your
machine has A4L and 8
loaded and you receive a A5K size
message, check the A5K column of
the table below. The paper size at the
top has the highest priority. In this
1
case, since 8 / " 11"L is a higher pri-
2
ority than A4L, the message is print-
1
ed on 8 / " 11"L.
2
1
/ " 11"L
2