Table of Contents
Advertisement
IM-50BAA-LM
When scale builds up on BC actuator paddle, BC should be cleaned.
CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are
securely in place after the icemaker is serviced. Make sure that none have fallen
into the dispense unit/ice storage bin.
1) Remove the front panel and then move the control switch to the "OFF" position. Unplug
the appliance.
2) Remove the top panel, top insulation, and top sheet.
3) Clear any ice away from BC.
4) Remove BC from the mechanism base, then carefully remove the microswitch lead
connector and move out of the icemaker for cleaning.
5) Remove the actuator paddle from the BC box. Then, remove the actuator plate from the
actuator paddle.
6) Wipe down the actuator paddle and actuator plate with a mixture of 1 part of Hoshizaki
"Scale Away" and 25 parts of warm water. Rinse the parts thoroughly with clean water.
7) Reassemble BC and replace it in its correct position.
Note: Carefully refit the actuator paddle to prevent deformation of the microswitch lever
in the BC box.
8) Refit BC to the mechanism base and reconnect the microswitch lead connector. Then,
replace the top sheet, top insulation, and top panel.
9) Plug in the appliance. Move the control switch to the "ICE" position.
10) Replace the front panel in its correct position.
Legend: BC–bin control; CB–control board
Bin Control Bracket
Actuator Paddle
Actuator Plate
WARNING
Cover
21
Box
Microswitch
Stretch box
with a flat blade
screwdriver
Stretch here with
your fingers
Advertisement
Table of Contents
