Cursor Echo - Raymarine SL70M Owner's Handbook Manual

4-6
Figure 4-2:
➤ To cancel the MOB, press and hold the MARK key for 2 seconds.
MARKS
Note: The MOB procedure can also be initiated or cancelled remotely if the
appropriate SeaTalk message is received by the Pathfinder Radar.

4.5 Cursor Echo

In a system with any chart display connected via Seatalk, you can set the
display to enable cursor transfer. Cursor echo (accessed from the Set Up
Menu) enables you to display a chart cursor on the radar picture, or a radar
cursor on the chart picture (you cannot display a remote radar cursor in a radar
window, nor a remote chart cursor in a chart window).
The following options are provided:
• Radar Cursor In : - not valid for SL70C and SL70M displays.
• Chart Cursor In: displays the cursor from another chartplotter on the
radar window (default - OFF ).
Note: The remote display must have SeaTalk Cursor Out enabled.
• SeaTalk Cursor Out: enables the output, onto SeaTalk, of the display's
own cursor (default - OFF ).
• Cursor Echo Local: - not valid for SL70C and SL70M displays.
When the appropriate option is switched on, the display shows its own cursor,
plus the cursor of the other display(s) with appropriate cursor text ( RDR or CHT )
to indicate its origin. This means that you could move the cursor over a target
on the radar display, and check the identity of the target by looking at the radar
cursor position on the chartplotter.
Refer to Section 5.3 for cursor echo set up details.
SL70M & SL70C PLUS Pathfinder Radar Displays
MOB Alarm