Mounting The Display Unit - Raymarine SL70M Owner's Handbook Manual

6-10

6.5 Mounting the Display Unit

The display unit is waterproof to CFR46 and can be installed either above or
below deck. The display unit can be mounted using the mounting bracket
supplied, or console mounted using the optional flush-mounting kit (see
Section 6.2).
Mounting Bracket
The display unit can be mounted on a dash, chart table, bulkhead or deckhead.
Figure 6-5:
1. Loosen the knobs and remove the mounting bracket from the display unit.
2. Mark the locations of the mounting bracket screw holes on the mounting
surface.
3. Use the screws supplied to attach the mounting bracket at the marked loca-
tions.
4. Attach the display unit to the mounting bracket, adjust the display angle
and tighten the knobs.
Console Mounting
The display unit can be console mounted if required, using the optional flush-
mounting kit (M92708).
CAUTION:
Make sure there are no hidden electrical wires or other items behind the
location before proceeding. Make sure there is sufficient rear access for
mounting and cabling.
SL70M & SL70C PLUS Pathfinder Radar Displays
Display Mounting