Cursor Echo - Raymarine DSM300 User Manual

32
Table 3-2: NMEA Sentences
Sentence
RTE
TTM
VHW
VLW
WPL
GGA
GLL
RMA
RMC
VTG
ZDA
The changes do not take effect until after ENTER is pressed. Consult your NMEA
instrumentation documentation to determine which strings should remain ON.
The DSM300 outputs the same depth value for DBT and DPT, regardless of the
Note:
Depth Offset value in Sonar Setup.

Cursor Echo

You can set up an integrated system so that radar and chartplotter displays
connected via SeaTalk can display each other's cursors.
Cursor echo functions so that you can display a chart cursor on the radar picture,
or a radar cursor on the chart picture (you cannot display a remote radar cursor in
a radar window nor can you display a remote chart cursor in a chart window).
When the appropriate options are switched on, each display shows its own cursor,
plus the cursor of the other display with appropriate cursor text (RDR or CHRT) to
indicate its origin. This means that you could move the cursor over a target on the
radar display and check the identity of the target by looking at the radar cursor
position on the chartplotter.
Press the CURSOR ECHO soft key to display the cursor transfer soft keys. The
following options can be toggled ON or OFF:
DSM300 Operation with PLUS Series Displays
Meaning
Routes
Tracked Target Message
Water Speed and Heading
Distance Travelled through the Water
Waypoint Location
Global Positioning System Fix Data
Geographic Position – Latitude/Longitude
Recommended Minimum Specific Loran-C Data
Recommended Minimum Specific GPS/TRANSIT
Data
Course Over Ground and Ground Speed
Time and Date