Replace Transaxle Drive Belt - Gravely 992274 Operator's Manual

REPLACE TRANSAXLE DRIVE
BELT
Remove Transaxle Drive Belt
1. Place unit in service position. See
Service Position on page 23.
2. Remove PTO belt from clutch. See
Remove PTO Belt on page 34.
CAUTION: Use care when
releasing idler spring tension.
Keep body parts away from
idlers when performing this
operation.
3. Slowly remove spring hook from eye bolt
to release transaxle idler belt tension.
See Figure 52.
3
1. Transaxle Idler
2. Spring
3. Eye Bolt
Figure 52
4. Remove hardware securing clutch stop
bracket to frame and remove bracket.
See Figure 53.
1
1. Clutch Stop Bracket
2. Clutch
Figure 53
2
1
2
5. Remove clutch stop. See Figure 54.
1
1. Clutch Stop
6. Remove hardware retaining transaxle
skid plate and remove skid plate. See
Figure 55.
7. Remove transaxle drive belt from drive
system in the following order:
a. From right transaxle sheave.
b. From left transaxle sheave.
c. From engine sheave.
Install Transaxle Drive Belt
See Figure 56.
1. Install transaxle drive belt to drive system
in the following order:
a. Around left transaxle sheave.
b. Around engine sheave.
c. Around right transaxle sheave.
2. Align belt with idler pulley.
3. Reinstall idler spring hook onto eye bolt.
Make sure belt has tension and is aligned
in all pulleys.
EN - 37
Figure 54
Figure 55