Usb Board Cable - HP 17-u199 Maintenance And Service Manual

USB board cable

Description
USB board cable
USB board FFC cable
Before removing the USB board cables, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
6. Remove the hard drive (see
7. Remove the WLAN module (see
8. Remove the USB board (see
Remove the USB board cables:
1. Release the ZIF connector (1) to which the USB board FFC cable is connected, and then disconnect
the USB board FFC cable (2) from the system board.
2. Disconnect the USB board cable (3) from the system board.
Reverse this procedure to install the USB board cables.
42 Chapter 5 Removal and replacement procedures
Bottom cover on page
Hard drive on page 33).
WLAN module on page
USB board on page 39).
26).
Battery on page 28).
34).
Spare part number
857837-001
857833-001