Function Buttons
Reverse Button
Press and hold the Reverse button to sew in reverse. Release it to resume sewing forward. The machine sews in
reverse only as long as the reverse button is pressed. Only available for the following: straight stitch and zigzag
stitch - 1-001 to 1-003, 1-008, and 1-010 to 1-012.
Start/Stop
Press the Start/Stop button to start and stop the machine sewing or embroidering without using the foot control.
Press Start/Stop to begin and touch again to stop.
Needle Up/Down
Press Needle Stop Up/Down to set the position of the needle when you stop sewing. The needle will move up or
down when you touch the button.
Tip: You can also tap the foot control to raise or lower the needle once you stop sewing.
Speed Control Lever
All stitches in your sewing machine have a pre-set, recommended sewing speed. You can adjust the speed using
the Speed Control Lever. Slide the lever to the left to decrease the speed and to the right to increase the speed.
You cannot select a higher speed than the default max speed for the selected stitch.
Cut Function
Press the cut function button after you stop sewing and your machine cuts the top and bobbin threads.
Basic Gestures for the Touch Screen
Easily navigate on the touch screen with the gestures described
below.
1. Touch — Touch once on a button or setting on the screen to
select.
2. Touch and Move — Touch once on a selected design and,
without releasing, move your finger to a different position
on the screen. Used e.g. for moving a design in the embroi-
dery area.
1
2
Introduction – 5