Volvo XC40 2019 Owner's Manual page 465

4. Locate programming button
receiver for the garage door or similar. It is
normally located close to the antenna's
bracket on the receiver.
5. Depress and release the receiver's pro-
gramming button once. The programming
must be completed within 30 seconds of
the button being depressed.
6. Press and release the button on
®
HomeLink that you want to program.
Repeat the sequence of pressing/holding/
releasing a second time and, depending
on the receiver model, even a third time.
> Programming is now be complete and
the garage door, gate or similar should
now be activated when the pro-
grammed button is depressed.
In the event of programming problems, con-
®
tact HomeLink at www.HomeLink.com, or
36 Button designation and colour varies between manufacturers.
37 Note that the toll-free number may not be available depending on operator.
call 00 8000 466 354 65 (or the toll number
+49 6838 907 277)
Reprogramming individual buttons
To reprogram an individual HomeLink
proceed as follows:
1. Press the desired button and hold it
depressed for approx. 20 seconds.
2. Once the indicator lamp on HomeLink
36
on the
starts to flash slowly, programming can
continue as normal.
Note: If the button to be reprogrammed is
not programmed with a new unit, it will
resume the previously saved program-
ming.
Resetting the HomeLink
It is only possible to reset all of the HomeLink
buttons at the same time, not each button
individually. Individual buttons can only be
reprogrammed.
Press and hold depressed the outer but-
–
tons (1 and 3) on HomeLink
10 seconds.
> When the indicator lamp changes over
from a constant glow to starting to
flash, the buttons are reset and ready to
be reprogrammed.
Related information
37 .
•
•
®
button, •
®
®
buttons
®
®
for approx.
STARTING AND DRIVING
®
Using HomeLink * (p. 464)
®
HomeLink * (p. 461)
®
Type approval for HomeLink * (p. 464)
* Option/accessory.
463