Pioneer Elite VSX-LX301 Basic Manual page 56

> Specifications > Specifications > Settings > Settings > Listening Modes > Playback Function
height speaker. Use this screen to select whether you have connected a subwoofer and
to select the type of height speaker, etc.
• If you have connected a subwoofer, check the power and volume of the subwoofer.
The low frequencies played by the subwoofer may not be discernible, so set its
volume to at least halfway.
3. Test tones are emitted by the speakers, and firstly the unit detects the speakers
connected and the noise in the environment.
4. After the results of the above measurements are displayed, select "Next", press ENTER
on the remote controller, and the test tones are emitted again, and the unit automatically
makes settings such as the optimum volume level and the crossover frequency.
5. When the measurement is completed, the measurement result is displayed.
Press the cursors / on the remote controller to check the settings. Press ENTER
when "Save" is selected to save the settings.
6. Disconnect the speaker setup microphone.
24 24
> Listening Modes > Playback Function
Manual MCACC
■ EQ Adjust
If you perform Full Auto MCACC then settings are automatic, but you can also adjust the
output volume of the range of each connected speaker to suit your own preferences. You
can adjust the volume of the different sound ranges for each of the speakers. You can set
three different equalizers in Preset 1 to 3. You can select up to 4 bands for the Subwoofer
and 9 bands for all other speakers.
Setting Item Default Value
Front Left 0 dB
Center 0 dB
Front Right 0 dB
> Basic Manual > Basic Manual
Troubleshooting Appendix Troubleshooting Appendix
Setting Details
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "−12.0 dB"
and "＋12.0 dB" with / .
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "−12.0 dB"
and "＋12.0 dB" with / .
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "−12.0 dB"
and "＋12.0 dB" with / .
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
| |
/ , adjust
/ , adjust
/ , adjust