Pioneer Elite VSX-LX301 Basic Manual page 42

> Specifications > Specifications > Settings > Settings > Listening Modes > Playback Function
Setting Item Default Value
Surround Small
Surround Back Small
Crossover 80Hz
10 10
> Listening Modes > Playback Function
Setting Details
Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• When "Front" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• This cannot be selected under the following
conditions:
– "System Setup" - "Speaker" - "Configuration"
- "Bi-Amp" is set to "Yes"
– "Zone 2" is set in "System Setup" - "Speaker"
- "Configuration" - "Zone Speaker".
• When "Surround" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
When there are speakers that have been set to
"Small", set the Hz under which you would like
other speakers to play bass, and also set Hz under
which you would like the LFE (low frequency effect)
to play the bass.
The value from "50Hz" to "200Hz" can be set.
Setting Item Default Value Setting Details
Double Bass Off This can be selected only when "System Setup" -
"Speaker" - "Configuration" - "Subwoofer" is set to
"Yes" and "Front" is set to "Large".
Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
> Basic Manual > Basic Manual
Troubleshooting Appendix Troubleshooting Appendix
• The setting will not automatically be configured
even if you performed Full Auto MCACC.
| |