Heath Zenith 7762 Manual page 2

2
Chime
Volume
CHIME
VOLUME
TUNE:
HOLD 1 SEC
SYNC:
HOLD 3 SEC
RESET:
HOLD 10 SEC
Figure 3
Figure 4
3-5/16"
(8.4 cm)
Figure 5
Holes
for Wall
Mounting
Figure 6
Helpful Videos – www.hzsupport.com
5. Adjust volume control. Adjust volume control
to desired volume (see Figure 3).
6. Mount push button. Use either screws or
double sided tape to mount push button.
• Screw Mounting: To mount with screws,
remove back of case by pushing in tab on
bottom with a small screwdriver (see Figure
1). Note: Remove material in screw holes
(if needed) before mounting with screws.
Attach back of case to door jamb or wall (see
Figure 4). Snap front of push button on.
• Tape Mounting: When attaching push but-
ton using double sided tape, make sure the
surface of the door jamb or wall is clean.
7. Mount chime. Chime can be mounted by
using 3 holes in the back of case, or by using
2 screws with keyholes.
Keyhole Mounting: Determine mounting
location.
• Mark two hole locations 3-5/16" (8.4 cm)
apart. Note: Make sure holes are level
before drilling.
• Drill two 7/32" diameter pilot holes for wall
anchors and insert anchors.
• Mount keyhole screws to wall leaving about
1/8" (3 mm) of the screw threads exposed.
• Using keyholes on back of chime base, hang
base on screws (see Figure 5).
Screw Mounting: Determine mounting location.
• Place chime against wall and verify the
chime is level.
• Use chime holes as a template (see Figure
6). Drill three 7/32" diameter pilot holes for
wall anchors (provided) and insert anchors.
• Insert 3 screws (provided) through holes in
back of chime.
• Verify chime is level and tighten screws
securely.
Helpful Answers – 1-800-858-8501