Download
Share
Print this page
Heath Zenith 7309 Instructions
  1. Manuals
  2. Brands
  3. Heath Zenith Manuals
  4. Accessories
  5. 7309
  6. Instructions

Heath Zenith 7309 Instructions

Wireless chime
Hide thumbs Also See for 7309:
1
2
3
4
5

Advertisement

Quick Links

Download this manual
This package includes (Style of push button and chime may vary from illustration):
Model
7309
7312
This chime requires 3 "C" alkaline batteries (not included). In typical use, alkaline
batteries will last up to one year.
Figure 1
Chime Volume Control
Figure 2
Figure 3
© 2018 HeathCo LLC
Wireless
chime
✔
✔
WARNING: To prevent possible SERIOUS
INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify
doctor.
1. Remove orange battery tab from push button.
Remove back of case by pushing in tab on bottom
with a small screwdriver (see Figure 1). Remove
orange battery tab.
2. Install 3 alkaline "C" batteries. Press in latch on
rear of chime and lift off battery cover (see Figure 2).
Install 3 alkaline "C" batteries (not included) into
chime. Make sure batteries are installed according
to the diagram inside the chime (see Figure 3).
Replace battery access door onto back of chime.
3. Test range. Temporarily position chime and push
button where you want them mounted. Press push
button to verify chime and push button work prop-
erly. If chime does not sound, see Troubleshooting.
4. Adjust volume control to desired volume (see
Figure 2).
Wireless Chime
Wireless push
button
✔
✔ (x2)
Hardware
pack
✔
✔

Advertisement

loading

Related Manuals for Heath Zenith 7309

Summary of Contents for Heath Zenith 7309

  • Page 1 This package includes (Style of push button and chime may vary from illustration): Wireless Wireless push Hardware chime button pack Model 7309 ✔ ✔ ✔ 7312 ✔ (x2) ✔ ✔ This chime requires 3 “C” alkaline batteries (not included). In typical use, alkaline batteries will last up to one year.
  • Page 2 5. Mount push button. Use either screws or double sided tape to mount push button. • Screw Mounting: To mount with screws, remove back of case by pushing in tab on bottom with a small screwdriver (see Figure 1). Note: Remove material in screw holes (if needed) before mounting with screws.

  • Page 3: Push Button

    Tune Settings The chime has different selectable tunes: Ding (one note tune), Ding-Dong (two note tune), Westminster, or Whittington. The factory setting is for the Westminster tune. This tune can be changed by following the instructions in the Tune Setting Table. Note: All chime models are designed to work with up to 5 push buttons (sold separately).

  • Page 4: Troubleshooting

    Troubleshooting 1. PROBLEM: Chime does not sound. A. POSSIBLE CAUSE: Push button and chime are not synced. A. CORRECTIVE ACTION: Sync the push button and chime. • Press and hold the button on the chime until the chime sounds a “Beep- Beep”.
  • Page 5 3. PROBLEM: Chime sounds when not intended (false triggers). POSSIBLE CAUSE: Chime is receiving interference from another wireless device. CORRECTIVE ACTION: Reset chime and push button. • Remove push button battery. Wait 30 seconds. • Press and hold the push button for 10 to 15 seconds within 60 seconds after installing battery into the push button.

This manual is also suitable for:

7312Sl-7312