Page 1
Wireless Chime This package includes (Style of door sensor and chime may vary from illustration): Chime base Chime cover Wireless push Hardware button pack 3x - “C” TYPE BATTERIES Model 7611 ✔ ✔ ✔ ✔ 7464 ✔ ✔ ✔ ✔ This chime requires 3 “C”...
Page 2
3. Test range. Temporarily position chime and push button where you want them mounted. Press push button to verify chime and push button work properly (see Figure 3). If chime does not sound, see Troubleshooting. 4. Adjust volume control. Turn volume control 3x - “C”...
Page 3
Tune Settings The chime has different selectable tunes: Ding (one note tune), Ding-Dong (two note tune), or Westminster (eight note tune). The factory set- ting is for the Westminster tune. This tune can be changed by following the instructions in the Tune Setting Table.
Troubleshooting 1. PROBLEM: Chime does not sound or rang one time and quit. A. POSSIBLE CAUSE: Push button and chime are not synced. A. CORRECTIVE ACTION: Sync the push button and chime. • Press and hold the button on the chime until the chime sounds a “Beep-Beep”.
Page 5
• Press the push button within 30 seconds. The chime will sound a “Beep-Beep” tone to indicate the push button is synced. • Press the push button to ensure operation. Note: The push button and chime come synced from the factory. The range of the wireless chime can vary with location, temperature, and battery condition.