Table of Contents
Advertisement
Progress of programme
Progress of a running programme can
be followed from the Programme Follow-
up indicator. At the beginning of every
programme step, the relevant indicator light
will turn on and light of the completed step
will turn off.
You can change the auxiliary functions,
speed and temperature settings without
stopping the programme flow while the
programme is running. To do this, the
change you are going to make must be in
a step after the running programme step.
If the change is not compatible, relevant
lights will flash for 3 times.
C
If the machine does not pass to the
spinning step, Rinse Hold function
might be active or the automatic
unbalanced load detection system
might be activated due to the
unbalanced distribution of the laundry
in the machine.
Loading door lock
There is a locking system on the loading
door of the machine that prevents opening
of the door in cases when the water level is
unsuitable.
Loading door light will start flashing when
the machine is switched to Pause mode.
Machine checks the level of the water
inside. If the level is suitable, Loading Door
light illuminates steadily within 1-2 minutes
and the loading door can be opened.
If the level is unsuitable, Loading Door
light turns off and the loading door cannot
be opened. If you are obliged to open
the Loading Door while the Loading
Door light is off, you have to cancel the
current programme; see "Cancelling the
programme".
Changing the selections after
programme has started
Switching the machine to pause mode
Press the Start / Pause button to switch
the machine to pause mode while a
programme is running. The light of the
step which the machine is in starts flashing
in the Programme Follow-up indicator to
show that the machine has been switched
to the pause mode.
Also, when the loading door is ready to
be opened, Loading Door light will also
illuminate continuously in addition to the
programme step light.
Changing the speed and temperature
settings for auxiliary functions
Depending on the step the programme has
reached, you may cancel or activate the
auxiliary functions; see, "Auxiliary function
selection".
You may also change the speed and
temperature settings; see, "Spin speed
selection" and "Temperature selection".
C
If no change is allowed, the relevant
light will flash for 3 times.
Adding or taking out laundry
Press the Start / Pause button to switch
the machine to pause mode. The
programme follow-up light of the
relevant step during which the machine
was switched into the pause mode will
flash.
Wait until the Loading Door can be
opened. Open the Loading Door and
add or take out the laundry. Close the
Loading Door. Make changes in auxiliary
functions, temperature and speed settings
if necessary. Press Start / Pause button to
start the machine.
Cancelling the programme
To cancel the programme, turn the
Programme Selection knob to select
another programme. Previous programme
will be canceled. End / Cancel light
will flash continuously to notify that the
programme has been canceled.
Your machine will end the programme
when you turn the Programme Selection
knob; however, it does not drain the
water inside. When you select and start
a new programme, the newly selected
programme will start depending on
the step the previous programme was
canceled in. For example, it may take in
additional water or continue to wash with
the water inside.
C
Depending on the step where the
programme was canceled in, you may
have to put detergent and softener
again for the programme you have
selected anew.
24
EN
Advertisement
Table of Contents
