Progress Of Programme; Loading Door Lock; Cancelling The Programme - Beko WTV 7712 XSW User Manual

4.3.13 Progress of programme

Progress of a running programme can be
followed from the Programme Follow-up
indicator. At the beginning of every programme
step, the relevant indicator light will turn on and
light of the completed step will turn off.
You can change the auxiliary functions, speed
and temperature settings without stopping
the programme flow while the programme
is running. To do this, the change you are
going to make must be in a step after the
running programme step. If the change is not
compatible, relevant lights will flash for 3 times.
C
INFORMATION
• If the machine does not pass to the spinning
step, Rinse Hold function might be active or the
automatic unbalanced load detection system
might be activated due to the unbalanced
distribution of the laundry in the machine.

4.3.14 Loading door lock

There is a locking system on the loading door of
the machine that prevents opening of the loading
door in cases when the water level is unsuitable.
Loading door light will start flashing when the
machine is switched to Pause mode. Machine
checks the level of the water inside. If the level is
suitable, Loading Door light illuminates steadily within
1-2 minutes and the loading door can be opened.
If the level is unsuitable, Loading Door light
turns off and the loading door cannot be
opened. If you are obliged to open the Loading
Door while the Loading Door light is off, you
must cancel the current programme. See.

"Cancelling the programme"

4.3.15 Changing the selections
after programme has started
Switching the machine to pause mode
Press the Start / Pause button to switch the
machine to pause mode while a programme
is running. The light of the step which the
machine is in starts flashing in the Programme
Follow-up indicator to show that the machine
has been switched to the pause mode.
Also, when the loading door is ready to be
opened, Loading Door light will also illuminate
continuously in addition to the programme step light.
18 / EN
Changing the auxiliary function, speed and
temperature
Depending on the step the programme has
reached, you can cancel or select the auxiliary
functions. See, "Auxiliary function selection".
You can also change the speed and
temperature settings. See, "Spin speed
selection" and "Temperature selection".
C
INFORMATION
• If no change is allowed, the
relevant light will flash 3 times.
Adding or taking out laundry
1. Press Start / Pause button to switch the
machine to pause mode. The programme
follow-up light of the relevant step during
which the machine was switched into the
pause mode will flash.
2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out
the laundry.
4. Close the Loading Door.
5. Make changes in auxiliary functions,
temperature and speed settings if necessary.
6. Press Start / Pause button to start the machine.
4.3.16 Cancelling the programme
To cancel the programme, turn the Programme
Selection knob to select another programme.
Previous programme will be cancelled. End /
Cancel light will flash continuously to notify that
the programme has been canceled.
Your machine will end the programme when you
turn the Programme Selection knob; however,
it does not drain the water inside. When you
select and start a new programme, the newly
selected programme will start depending on the
step the previous programme was canceled in.
For example, it may take in additional water or
continue to wash with the water inside.
Washing Machine / User's Manual