Table of Contents
Advertisement
Proceed as follows:
1. Working from the front,
insert the device into the
mounting cut-out. Secure
the device to prevent it from
falling out.
2. Insert a mounting clip into
the cutout provided on the
device. Make sure it is in the
correct position; see the
section "Mounting clips or
mounting brackets, position
for IP65 (Page 45)".
3. Tighten the threaded pin to
secure the mounting clip.
The maximum torque when
tightening the threaded pins
of the mounting clips is 0.5
Nm.
4. Repeat steps 2 and 3 for all
mounting clips.
5. Check the fit of the
mounting seal.
Mounting with optional mounting brackets
Mounting brackets can be used instead of mounting clips in steps 1 to 5:
IFP, IFP PRO, IFP ETH
Operating Instructions, 09/2019, A5E31298376-AJ
Installing and connecting the device
3.2 Installing the built-in unit
47
Advertisement
Table of Contents
