Memory Modules - HP Z VR Backpack G1 Maintenance And Service Manual

Memory modules

Description
SODIMM, 8 GB, 2400 MHz, 1.2 v, DDR4
SODIMM, 16 GB, 2400 MHz, 1.2 v, DDR4
NOTE: It is not necessary to remove the memory module to remove the system board. Remove the memory
module only if it needs to be replaced.
Follow these steps to remove the memory modules:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the top cover (see
5. Remove the fans (see
6. Remove the antenna (see
7. Remove the battery (see
8. Remove the SSD (see
9. Remove the heat sink (see
10. Press in on the sides of the DIMM memory modules cover (1), then lift and remove the cover from the
modules (2).
11. Spread the two retention clips outward (1) until the memory modules tilt up at a 45-degree angle.
22 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Top Cover on page 14).
Fans on page 16).
Antennas on page 18).
Battery on page 19).
Solid state drive on page 20).
Heat sink on page 21).
Spare part number
862398-855
865396-855