Memory Modules; Memory Module Specifications; Removing Memory Modules - HP 260 G3 Maintenance And Service Manual

Memory modules

The computer comes with at least one small outline, dual in-line memory module (SODIMM). To achieve
maximum memory support, you can populate the system board with up to 32 GB of memory.

Memory module specifications

For proper system operation, the memory modules must meet the following qualifications:
Specifications
Memory modules
Compliance
Pins
Support (latency)
Slots
Maximum memory
Support (Gbit)
Note
HP offers upgrade memory for this computer and advises that the consumer purchase it to avoid
compatibility issues with unsupported third-party memory.

Removing memory modules

For a list of available memory modules, see
There are two memory module slots on the system board, with one slot per channel. The slots are labeled
DIMM1 and DIMM3. The DIMM1 slot operates in memory channel B. The DIMM3 slot operates in memory
channel A.
1.2-volt DDR4-SDRAM memory modules
Unbuffered non-ECC PC4-21300 DDR4-2666 MHz-compliant
Industry-standard 260-pin containing the mandatory Joint Electronic Device Engineering
Council (JEDEC) specification
Support CAS latency 19 DDR4 2666 MHz (19-19-19 timing)
2
32 GB
2 Gbit, 4 Gbit, and 8 Gbit, non-ECC memory technologies single-sided and double-sided
memory modules
The system will not operate properly if you install unsupported memory modules.
Memory modules constructed with x8 and x16 DDR devices are supported; memory
modules constructed with x4 SDRAM are not supported.
Computer major components on page 4.
Memory modules 25