Table of Contents
Advertisement
3 - Preparation
3 - 1
Power sources
This unit can operate on 2 AAA batteries (sold separately) or USB bus
power using the included USB cable.
NOTE
This unit can use alkaline, Ni-MH or lithium AAA batteries.
Using AAA batteries (sold separately)
1.
Open the battery compartment cover on the back of the unit.
While gently pressing the battery compartment cover, slide it and
lift it slowly to open the compartment.
2.
Install 2 AAA batteries with their ¥ and ^ marks as shown in the
battery compartment, and close the cover.
NOTE
When using AAA batteries, set the type of battery in order to accurately
show the amount of power remaining and allow the unit to accurately
determine whether power is available for proper operation. This is set to
ALKALINE when shipped new from the factory. See "Setting the battery
type" on page 27 for procedures to change settings.
CAUTION
o AAA manganese dry cell batteries cannot be used with this unit.
o This unit cannot recharge AAA Ni-MH batteries. Use a commercially-available
recharger.
8
TASCAM DR-10L Pro V1.00
Using USB bus power
Use the included USB cable to connect the unit to a USB port on a
computer.
USB Type-C port
USB cable
NOTE
o If a computer is going to be used only to supply power, settings do
not need to be made on this unit.
o If USB bus power is supplied to this unit when its power is off, it will
automatically turn on.
o If both batteries and USB bus power are provided, the USB bus power
supply will be used first.
CAUTION
o If this unit is run only on USB bus power without batteries installed, it
will turn off if the USB bus power supply is interrupted.
If the power turns off during operation, the equipment could be
damaged and data could be lost, for example. We highly recommend
installing batteries in the unit even when using USB bus power.
o The unit should be connected directly to the computer, not through
a USB hub.
o Operation is not guaranteed when using a portable USB battery.
Computer
Advertisement
Table of Contents
