Check The Status [Status] - Panasonic i-Pro WV-SP500 Series Operating Instructions Manual

20 Maintenance of the camera [Maintenance]
4.
Click the [Execute] button.
→
The confirmation window will be displayed. When "Do not reset the settings to the default after the
upgrade." is selected, the confirmation window will not be displayed.
IMPORTANT
•
After completing the upgrade, delete temporary internet files. (®page 189)
•
Upgrade the firmware using a PC in the same subnet as the unit.
•
Follow the instructions from the dealer when upgrading the firmware.
•
When upgrading the application software, use the designated file (extension: img) for the firmware
upgrade.
The name of the firmware to be used for the upgrade should be "model name (Use small letters.
"WV-" is not required.)_xxxxx.img".
* ("xxxxx" indicates the version of the firmware.)
•
Do not turn off the power of the camera during the upgrade process.
•
Do not perform any operation during upgrading and wait until it completes.
•
The following network settings will not be reset when upgrading the firmware after selecting "Reset the
settings to the default after completing the upgrade. (Except the network settings)".
On/Off for DHCP, IP address, subnet mask, default gateway, HTTP port, HTTPS port, connection
protocol (HTTP/HTTPS), CRT key, server certificate, UPnP setting, line speed, bandwidth control (bit
rate), time & date
•
The viewer software used on each PC should be licensed individually. Refer to your dealer for the
software licensing.

20.3 Check the status [Status]

Click the [Status] tab of the "Maintenance" page. (®page 41, page 43)
The status of this camera can be checked on this page.
[Viewnetcam.com]
•
Server: The URL of the "Viewnetcam.com" service server will be displayed.
182 Operating Instructions