Check The Status [Status] - Panasonic WV-X6531N Operating Instructions Manual

2 Settings
2.
Click the [Browse...] button and designate the downloaded firmware.
Note
•
The latest firmware upgrade is posted on our website. The firmware is in a zip file. After downloading
the file, unzip it and use the file with the ".img" extension to upgrade the firmware.
–
When using the camera in Japan
http://sol.panasonic.biz/security/support/index.html
–
When using the camera outside of Japan
http://security.panasonic.com/support/
•
To view the website, it is necessary to be connected to the internet.
3.
Click the radio button respective to the desired option to determine whether or not to initialize the settings
after completing the firmware upgrade.
Default: Do not reset the settings to the default after the upgrade.
Note
•
Note that the settings cannot be restored after an initialization is operated.
4.
Click the [Execute] button.
→
The confirmation window will be displayed.
IMPORTANT
•
After upgrading, make sure to check the version on this page.
•
After completing the upgrade, delete temporary internet files. (®page 253)
•
Upgrade the firmware using a PC in the same subnet as the unit.
•
Follow the instructions from the dealer when upgrading the firmware.
•
When upgrading the application software, use the designated file (extension: img) for the firmware
upgrade.
The name of the firmware to be used for the upgrade should be "model name (Use small letters.
"WV-" is not required.)_xxxxx.img".
* ("xxxxx" indicates the version of the firmware.)
•
Do not turn off the power of the camera during the upgrade process.
•
Do not perform any operation during upgrading and wait until it completes.
•
The following network settings will not be reset when upgrading the firmware after selecting "Reset the
settings to the default after completing the upgrade. (Except the network settings)".
Primary server address and secondary server address DNS settings for IPv4, primary DNS server
address and secondary DNS server address settings for IPv6, On/Off for DHCP, IP address, subnet
mask, default gateway, HTTP port, HTTPS port, connection protocol (HTTP/HTTPS), CRT key, CA
certificate, UPnP setting, line speed, bandwidth control (bit rate), time & date, preset position.
•
The viewer software used on each PC should be licensed individually. Refer to your dealer for the
software licensing.

2.11.3 Check the status [Status]

Click the [Status] tab of the "Maintenance" page. (®For menu display and how to operate, refer to page 47,
page 48)
236 Operating Instructions