Pcl Setup - Oki C332dnw User Manual

PCL S
ETUP
ITEM
FONT SOURCE
FONT NO.
FONT PITCH
FONT HEIGHT
SYMBOL SET
A4 PRINT WIDTH
WHITE PAGE SKIP
CR FUNCTION
LF FUNCTION
PRINT MARGIN
TRUE BLACK
PEN WIDTH ADJUST
SETTINGS EXPLANATION
RESIDENT Specifies the location of the PCL default font.
Normally this will be INTERNAL unless additional
fonts are installed in the expansion ROM slot or
additional fonts have been downloaded to RAM as
permanent fonts.
I0 Sets the current default font number from the
currently selected source.
~
I90
0.44 CPI Sets the width of the PCL default font in
characters/inch (CPI).
~
Default font is the fixed-pitch, scalable font. The
10.00 CPI
value is displayed to the second decimal place.
~
Displayed only when the font selected in Font No.
99.99 CPI
is fixed-spacing, scalable font.
4.00 POINT Height of the PCL default font.
~ Note: This menu item is displayed only when the
font selected in Font No. is a proportional-
12.00 POINT
spacing, scalable font.
~
999.75 POINT
PC-8 Selects a PCL symbol set.
(Default Symbol
Set
only shown)
78 COLUMN Sets the number of columns subject to Auto LF
with A4 paper in PCL. This is the value when Auto
80 COLUMN
CR/LF Mode is set to OFF with the 10CPI
character.
ON Selects whether blank pages are printed or not.
OFF
CR Selects whether a received carriage return
character (0Dh) also causes a line feed.
CR+LF
LF Selects whether a received line feed character
(0Ah) also causes a carriage return.
LF+CR
NORMAL Sets the non-printable page area. NORMAL is
PCL compatible.
1/5 INCH
1/6 INCH
ON PCL: Sets if to use Composite Black (CMYK
mixed) or Pure Black (K only) for the black
OFF
(100%) in image data.
ON When minimum width is specified in PCL,
sometimes a 1-dot line, looks broken.
OFF
With PEN WIDTH ADJUST set to ON, when the
minimum width is specified, the line width will be
emphasized so as to look wider than a 1-dot line.
With PEN WIDTH ADJUST set to OFF, the line
will appear as before.
Operator panel > 42