Table of Contents
Advertisement
7.
Press up or down on the operator panel to display WPS SETUP, and then press the
OK button.
8.
Select WPS-PBC, and then press the OK button.
9.
Select YES, and then press the OK button.
10.
The Printer starts searching for wireless LAN access points. During 2 minutes, press
the easy setup button for the wireless LAN access point for a few seconds.
Once the setup completion screen is displayed, it indicates that the wireless LAN
setup has completed.
Set the IP Address
Set a different IP address for the wireless LAN from that of the wired LAN. Enter the setting
menu and make the settings by the following procedure.
1.
Press up or down on the operator panel to display WIRELESS(INFRASTRUCTURE)
SETTING, and then press the OK button.
2.
Enter the Admin password and then press the OK button.
(The default password is 999999.)
3.
Press up or down on the operator panel to display NETWORK SETTING.
4.
AUTO or MANUAL in the IP ADDRESS SET.
If MANUAL is selected, manually input the IPv4 Address, Subnet Mask and Gateway
Address.
Installing upgrades > 67
Advertisement
Table of Contents
