Table of Contents
Advertisement
Malfunction
Program centrifuge
run does not start.
Sparkling, hissing
loud.
Long, growling
loudly before the start
of the wash or fabric
softener cycle.
Short, buzzing sound
after switching on
of the device.
Loud noise during
spin.
Clapping, rattling
in the pump.
Slurping, rhythmic
suction sound.
Creasing.
Cause and Troubleshooting
Drain pipe or water drain hose is kinked or
trapped.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or trapped.
The imbalance detection system has stopped the spin
cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
Launch the programCentrifuge.
▶
Water is flushed under pressure into the detergent
drawer.
No error - normal operating noise.
▶
Intelligent dosing system doses detergent or care
product.
No error - normal operating noise.
▶
Intelligent dosing system performs a function test.
No error - normal operating noise.
▶
The appliance is not leveled properly.
→ "Adjusting the device", page 16
▶
Device feet are not fixed.
Secure the device feet.
▶
→ "Adjusting the device", page 16
Transport protection devices have not been removed.
→ "Remove transport protection", page 14 .
▶
A foreign object has entered the pump.
→ "Clean the drain pump", page 42
▶
Pump is active, the suds are pumped out.
No error - normal operating noise.
▶
Spin speed is too high.
Set a lower spin speed for the next wash.
▶
The load amount is too high.
Reduce the load amount for the next wash.
▶
TroubleshootingNL
53
Advertisement
Table of Contents
