Bosch WAU28P02NL User Manual And Installation Instructions page 46

Table of Contents

Advertisement

NLTroubleshooting
Malfunction
"E:36 / -10"
"E:36 / -25 / -26"
"E:10 / -00 / -10 /
- 20"
"H:32"
"E:30 / -10" and/or
46
Cause and Troubleshooting
When dosing manually, reduce the amount of
detergent for the next wash with the same load.
Unauthorized extension fitted to the water drain
hose.
Remove unauthorized extensions to the water drain
hose.
"Connecting the device", page 15
Pump cover is not fully screwed in.
Make sure that the pump cover is screwed into the
device as far as it will go. The handle of the pump
cover must be vertical.
Drain pump is clogged.
→ "Clean the drain pump", page 42 .
Pump of the intelligent dosing system is blocked.
Turn off the device.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page
40
Turn on the device.
3.
If the indication reappears after cleaning the pump
4.
unit, call the service.
"After-sales service", page 58
Remark:Until the fault has been rectified, you can
deactivate the intelligent dosing system and dose
manually.
→ "Buttons", page 25
The imbalance detection system has stopped the spin
cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
Water pressure is low.
No solution possible.
The strainers in the water supply are clogged.
▶ Clean the strainers in the water supply.
Water tap is closed.

Advertisement

Table of Contents
loading

Table of Contents