Table of Contents
Advertisement
NLTroubleshooting
Malfunction
Door cannot be
opened.
Washing water is not
pumped out.
50
Cause and Troubleshooting
Open the door with the emergency release.
▶
→ "Emergency release", page 57
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
trapped.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or trapped.
Drain pump is clogged.
→ "Clean the drain pump", page 42
▶
is activated.
Resume the programCentrifugeorDrainto select
▶
and press .
Water drain hose is connected too high.
Mount the water drain hose at a maximum height of 1
▶
metre.
Pump cover not assembled correctly.
Assemble the pump cover correctly.
▶
Detergent dosage is too high.
Immediate measure: mix one tablespoon of fabric
▶
softener with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
When the intelligent dosing is activated, reduce the
▶
basic dosing amount
→ Page 38 .
When dosing manually, reduce the amount of
▶
detergent for the next wash with the same load.
Unauthorized extension fitted to the water drain
hose.
Remove unauthorized extensions to the water drain
▶
hose.
→
"Connecting the device", page 15
Pump cover is not fully screwed in.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The handle of the pump
cover must be vertical.
Advertisement
Table of Contents
