Table of Contents
Advertisement
Malfunction
"E:30 / -10" and/or
flashes.
Cause and Troubleshooting
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water supply hose is not
▶
kinked or trapped.
Water level measuring system defective.
Remark:With the error message, the device starts a
pump-down procedure.
First wait approx. 5 minutes until the pumping procedure
1.
has finished.
To reset the error message, turn off the device.
2.
Turn the device back on.
3.
If the error message appears again, please contact
4.
the service.
→
"After-sales service", page 58
Detergent drawer is not fully retracted.
▶ Slide in the detergent drawer until the symbol goes out.
Pump unit is not installed.
Place the pump unit in the detergent drawer.
1.
→ "Cleaning the detergent drawer", Page
40
Slide in the detergent drawer until the symbol goes out.
2.
The voltage monitoring system detects an
impermissible voltage drop.
No solution possible.
▶
Remark:When the supply voltage has stabilized, the
program continues normally.
Voltage undershoot can cause program extension.
No solution possible.
Detergent dosage is too high.
Immediate measure: mix one tablespoon of fabric
▶
softener with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
When the intelligent dosing is activated, reduce the
▶
basic dosing amount
→ Page 38 .
When dosing manually, reduce the amount of
▶
detergent for the next wash with the same load.
TroubleshootingNL
47
Advertisement
Table of Contents
