Table of Contents
Advertisement
Malfunction
No water flows into
the device. The
detergent was not
washed in.
Start several times
with centrifugation.
The program duration
changes during the wash
cycle.
The water is not
visible in the drum
bar.
Drum shakes
program start.
Vibration and movement
of the appliance
during the centrifuge
run.
Cause and Troubleshooting
was not pressed.
Press .
▶
The strainers in the water supply are clogged.
▶ Clean the strainers in the water supply.
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water supply hose is not
▶
kinked or trapped.
The imbalance control system removes the imbalance
by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, if possible, place large and
small items of laundry together in the drum. Laundry
of different sizes is distributed better during the spin
cycle.
The program sequence is optimized electronically. This
may lead to changes in the program duration.
No error - no action required.
▶
The imbalance control system removes the imbalance
by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, if possible, place large and
small items of laundry together in the drum. Laundry
of different sizes is distributed better during the spin
cycle.
Foam control system performs an extra rinse in case
of excessive foam formation.
No error - no action required.
▶
The water is below the visible range.
No error - no action required.
▶
▶
Do not fill the appliance with additional water during
operation.
The cause is an internal motor test.
No error - no action required.
▶
The appliance is not leveled properly.
→ "Adjusting the device", page 16
▶
Device feet are not fixed.
TroubleshootingNL
51
Advertisement
Table of Contents
