Table of Contents
Advertisement
Step 7
Mount the camera onto the camera mount bracket
(accessory). Fit the lock plate of the camera onto the
guide part of the camera mount bracket, and rotate the
camera clockwise after inserting the camera while putting
the center of the camera onto the center of the camera
mount bracket.
Approx. 20 °
Guide part
Lock plate
IMPORTANT:
• When mounting the camera onto the camera mount
bracket, hold the fixed section of the unit. Mounting
the camera while holding the dome section may result
in malfunction.
Step 8
Fix the camera on the camera mount bracket (accessory)
using the camera fixing screw (M3, accessory).
Recommended tightening torque: 0.68 N·m {0.50 lbf·ft}
Fixing screw
(M3, accessory)
Center of the
camera mount bracket
Fixed
section
Step 9
Connect a LAN cable and power cable to the camera.
<When using a PoE device>
Connect a LAN cable to the camera.
<When using a 12 V DC power supply>
After connecting a LAN cable to the camera, connect an
AC adaptor to the 12 V DC power supply terminal.
IMPORTANT:
• Do not touch the camera in the process of initializa-
tion. Otherwise, it may fail to initialize and may cause
malfunction.
Network connector
12 V DC power supply terminal
• Network connector
Connect a LAN cable (category 5 or better) to the network
connector.
IMPORTANT:
• Use all 4 pairs (8 pins) of the LAN cable.
• The maximum cable length is 100 m {328 feet}.
• Make sure that the PoE device in use is compliant
with IEEE802.3af standard.
• When connecting both the 12 V DC power supply
and the PoE device for power supply, 12 V DC will be
used for power supply.
* If a 12 V DC power supply and a PoE hub or router
are used at the same time, network connections
may not be possible. In this case, disable the PoE
settings. Refer to the operating instructions of the
PoE hub or router in use.
* Depending on the PoE device used, if you stop the
12 V DC power supply after operating it and a PoE
hub or router at the same time, the power supply
may stop, causing the camera to restart.
• When the LAN cable is disconnected once, reconnect
the cable after around 2 seconds. When the cable is
quickly reconnected, the power may not be supplied
from the PoE device.
• The network camera is only intended for a connection
to an ethernet or PoE network without routing to the
outside plant.
21
Advertisement
Table of Contents
