Table of Contents
Advertisement
Installing the camera on a ceiling
The following are descriptions of how to install the camera on a ceiling using the camera mount bracket (accessory). There
are 2 methods; wiring through a hole in the ceiling (☞ page 19) and wiring through a cable guide (unnecessary to make a
hole in the ceiling) (☞ page 23).
Wire through a hole in the ceiling
Step 1
Fix the camera mount bracket (accessory) with 4 screws
(M4, locally procured).
There should be no obstacles such as wall in a range of
100 mm {3-15/16 inches} away from the center point of
the camera mount bracket.
Shooting direction (FRONT)
83.5 mm
{3-9/32 inches}
100 mm {3-15/16 inches} or more
away from obstacles such as wall
Step 2
Make a hole in the ceiling to pass the cables through.
Make a hole 25 mm {31/32 inches} in diameter. The cen-
ter point of the hole should be located approx. 75 mm
{2-15/16 inches} away from the center point of the cam-
era mount bracket.
Wiring hole
(ø25 mm {31/32 inches})
Step 3
When using an SD memory card, insert the SD memory
card into the SD memory card slot before mounting the
camera to the mount bracket. Refer to page 16 for how to
insert the SD memory card.
Step 4
Remove the protective caps from connectors that you
intend to use. Keep the removed protective caps for future
use.
IMPORTANT:
• The protective caps are used to prevent dirt and dust
from entering inside this product. Keep the protective
caps inserted in connectors that are not used.
Step 5
Attach the safety wire fixed with the camera mount
bracket (accessory) to the camera.
After attaching the safety wire to the camera, confirm that
the ring part at the end of the safety wire is securely
hooked on the safety wire holder.
Protective caps
Safety wire
Safety wire holder
19
Advertisement
Table of Contents
