Preparing The Media - Panasonic SC-HC302 Operating Instructions Manual

Preparing the media

Disc
1
Press [USB/CD] to select "CD".
2
Press [CD x] (main unit: [x]) to open the sliding
door.
Put in a disc with the label facing towards you.
3
Press [CD x] (main unit: [x]) again to close the
sliding door.
Keep fingers away from the sliding door when it is
closing.
USB
USB device
(not supplied)
Press [USB/CD] to select "USB".
Note:
Do not use a USB extension cable. The system cannot
recognise USB device connected through a cable.
6
Bluetooth
®
You can connect and play an audio device wirelessly
through Bluetooth .
®
Preparation
• Switch on the Bluetooth
the device near the system.
• Read the operating instructions of the device for details.
█ Pairing a device
Preparation
If this system is connected to a Bluetooth
disconnect it. (~7)
1
Press [ ] to select "BLUETOOTH".
If "PAIRING" is shown, continue with step 3.
2
Press [PLAY MENU] to select "PAIRING".
Or press and hold [SELECTOR/ –
main unit until "PAIRING" is shown.
3
Select "SC-HC302" or "SC-HC300" from the
Bluetooth menu of the device.
®
If prompted for a passkey, input "0000".
The device connects with this system automatically
after pairing is complete.
The MAC address (example: 6C:5A:B5:B3:1D:0F)
may be shown before "SC-HC302" or "SC-HC300" is
shown.
The name of the connected device is shown for a few
seconds.
Note:
You can pair up to 8 devices with this system. If a 9th device is
paired, the device that has not been used for the longest time
will be replaced.
█ Connecting a device
Preparation
If this system is connected to a Bluetooth
disconnect it. (~7)
1
Press [ ] to select "BLUETOOTH".
"BLUETOOTH READY" is shown.
2
Select "SC-HC302" or "SC-HC300" from the
Bluetooth menu of the device.
®
The name of the connected device is shown for a few
seconds.
3
Start playback on the device.
Note:
•
A device must be paired to connect.
•
This system can only connect to one device at a time.
•
When "BLUETOOTH" is selected as the source, this system
will automatically try to connect to the last connected device.
("LINKING" is shown during this process.)
feature of the device and put
®
device,
®
PAIRING] on the
device,
®