Table of Contents
Advertisement
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Connect the single-pin connectors from the
LED assembly to the connectors from the fan.
Connect the white wires together. Connect the
blue and black wires together.
WARNING
FAN FALL HAZARD
Make sure screws are tight to secure the
light fixture.
Tab
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Ceiling Bracket
Downrod
Assembling the Light Kit
2 of 3
Light Kit Screw
bag
Installing the Glass
Notch
Hanging Fan
Wiring
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Rotate the keyhole slots around the screws
and twist counterclockwise. Install the third light
kit screw. Tighten all three screws securely.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
Canopy
Blades
1 of 3
Light Kit Screw
bag
bag
Raise cap to the LED assembly. Align the
notches on the sides of the cap with the
screw holes in the LED assembly. Install
the two light cap screws which can be
found in the
hardware bag.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light
LED/Glass
1886
2 of 2
Light Cap Screw
ON
8
Remote
Advertisement
Table of Contents
