Setting The Camera In - Pyle PLTV7R Owner's Manual

SETTING THE CAMERA IN

1. Connect a Back View Camera only to AV1,2 or 3 Input terminals on the rear of the unit.
* When the VCD changer is connected to AV3 Video input, The back view camera
can be connected only to AV1 or AV2 video input.
2. Press the MODE button to select radio mode.
3. Press the MENU button to select following picture.
4. Press the SEARCH UP/DOWN button to select CAMERA IN.
5. Press the VOLUME < or > button to select AV1,2 or 3 that Back View Camera is
connected. Each time you press this button, AV Input changes as
AV1 -> AV2 -> AV3 -> OFF -> AV1.
WATCHING THE BACK VIEW PICTURE
Set the rear gear on any mode. The monitor shows the back view camera picture.
NOTE
If AV Input connected to the Back View Camera is selected with the
MODE button, the monitor does not show the back view camera picture.
The monitor shows the WARNING picture.
16
CAMERA IN