Pyle PLTV7R Owner's Manual page 18

SETTING THE NAVIGATION
1. Connect a NAVIGATION system only to AV1 or AV2 Input terminals on the rear of the unit.
2. Press the MODE button to select radio mode.
3. Press the MENU button to select following picture.
4. Press the SEARCH UP/DOWN button to select NAVIGATION.
5. Press the VOLUME < or > button to select AV1 or AV2 connected to the
NAVIGATION system. Each time you press this button, AV Input changes as
AV 1 -> AV2 -> OFF -> AV1.
WATCHING THE NAVIGATION PICTURE
Press the NAVI button on radio or AV1, 2 or 3 mode. The monitor shows the navigation
picture.
NOTE
Do not select the AV mode connected to the NAVIGATION system with
the MODE button. If AV Input connected to the NAVIGATION system is
selected with the MODE button, the monitor does not show the
NAVIGATION picture. The monitor shows the WARNING picture.
NAVIGATION
15