CONTENTS Important Safety Instruction...3 Installation ...4 Installation Hardware ...4 Mounting the Tuner Unit ...5 Install the Display Unit ...5 DIN Front-Mount...5 DIN Rear-Mount...6 Electrical Connection ...7 Operation ...8 Location and Function of Keys...8 General Operation ...10 Radio Operation...11 CDC Operation ...11 TV Operation...12 Specification...15...
IMPORTANT SAFETY INSTRUCTION CAUTION: Please read and observe all warnings and instruction given in this owner’s manual and those marked on the unit. Keep these instructions. Retain this booklet for future reference. Please read the following safety instructions carefully. 1. This set has been designed and manufactured to assure personal safety. Improper use can result in electric shock or fire hazard.
INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly.
INSTALLATION Removing the unit 1. Lever Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers upward and out to makes it possible to remove the unit. DIN REAR-MOUNT Installation using the screw holes on the both sides of the unit.
ELECTRICAL CONNECTION RADIO/TV MAIN UNIT (VIEW FROM REAR) TV DIVERSITY ANTENNA INPUT CDC INPUT TO POWER SUPPLY CAUTION: 1. If the TV control grey cable is connected to car brake, when the car is running, you cannot switch into TV mode, and the is unavailable.
OPERATION GENERAL OPERATION • ON/OFF Switch on the unit by pressing PWR button (1). When system is on, press it again to turn it off. • SELECTING SOUND MODE Press SEL button (6) to move display through volume, bass, treble, balance and fader functions.
OPERATION RADIO OPERATION • SELECTING BAND Press BND button (11) to change between three FM bands and two AM bands and one LW band. Each band stores up to six preset stations. AM1/MW • SELECTING STATION During radio mode, press TUNE/SKIP button (13) to increase frequency or TUNE/SKIP button (14) to...
OPERATION TV OPERATION • REMOTE SENSOR On the screen display, there is a remote sensor IR (10) to receive remote control signal. You can point the remote control handset to IR (10) and press function keys on the handset to control TV. The unit is also connected an external remote receiver (See the electrical connection diagrams on Page 7 &...
Page 13
OPERATION In this case, you also need to consider if the IR (10) is available. Fig. 4 - When the display turns downward to a certain angle, it will draw in. Fig. 5 • SELECTING RECEIVING MODE Press TV/AV button (22) to select among AV1/AV2/TV.
Page 14
OPERATION • VOLUME ADJUSTMENT Press VOL + button (32) or VOL – button (33) to adjust volume level. • MUTE Press MUTE button (25) to mute the sound. Press the button again, the screen will display “VOLUME XXX” for about 4 seconds, and this is the AUDIO level setting value of the TV unit.
SPECIFICATION GENERAL Power Supply Voltage Maximum Power Load Impedance Tone Controls - Bass (at 100 Hz) - Treble (at 10 KHz) Monitor Screen Size Resolution TV Sensitivity RADIO Frequency Coverage Sensitivity (30 dB S/N) Image Rejection Stereo Separation Frequency Coverage Sensitivity (20 dB S/N) Image Rejection : DC 12 Volts, Negative Ground...