Fiber Optic Ethernet Ports; Sfp Optic Ethernet Ports - Siemens RUGGEDCOM RSG2100 Installation Manual

Chapter 3
Communication Ports
Section 3.2

Fiber Optic Ethernet Ports

Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer Registered Jack), LC (Lucent
Connector), SC (Standard or Subscriber Connector) or ST (Straight Tip) connectors. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
1
Figure 26: MTRJ Port
1. Tx Connector 2. Rx Connector
1
Figure 28: SC Port
1. Tx Connector 2. Rx Connector
For specifications on the available fiber optic Ethernet ports, refer to
Specifications".
Section 3.3

SFP Optic Ethernet Ports

SFP (Small Form-Factor Pluggable) optic Ethernet ports are available with LC (Lucent Connector) connectors.
Make sure the Transmit (Tx) and Receive (Rx) connections of each port are properly connected and matched to
establish a proper link.
Figure 30: LC Port
1. Tx Connector 2. Rx Connector
NOTE
SFP modules, as well as their optical ports, can be safely inserted and removed while the chassis is
powered and operating.
The following sections describe how to install and remove SFP optical ports:
22
2
Figure 27: LC Port
1. Tx Connector
2
Figure 29: ST Port
1. Tx Connector
1
1
2. Rx Connector
1
2. Rx Connector
Section 4.5, "Fiber Optic Ethernet Port
2
Fiber Optic Ethernet Ports
RUGGEDCOM RSG2100
Installation Guide
2
2