Table of Contents
Advertisement
RUGGEDCOM RX1100P
Installation Guide
For specifications on the available copper Ethernet ports, refer to
Specifications".
Section 3.2
Fiber Optic Ethernet Ports
Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer Registered Jack), LC (Lucent
Connector), SC (Standard or Subscriber Connector) or ST (Straight Tip) connectors. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
1
Figure 17: MTRJ Port
1. Tx Connector
2. Rx Connector
1
Figure 19: SC Port
1. Tx Connector
2. Rx Connector
For specifications on the available fiber optic Ethernet ports, refer to
Specifications".
Section 3.3
WAN Ports
The RX1100P can optionally be equipped with T1/E1 WAN ports, which communicate on standard telephony
communication lines.
T1/E1 WAN ports are equipped with standard RJ45 receptacles. The following is the pin-out for the T1/E1 ports:
8
Figure 21: RJ45 T1/E1 Port Pin Configuration
Fiber Optic Ethernet Ports
2
Figure 18: LC Port
1. Tx Connector
2
Figure 20: ST Port
1. Tx Connector
1
Section 4.4, "Copper Ethernet Port
1
2. Rx Connector
1
2. Rx Connector
Section 4.5, "Fiber Ethernet Port
Pin
1
2
3
Reserved (Do Not Connect)
4
5
Chapter 3
Communication Ports
2
2
Description
RRING
RTIP
TRING
TTIP
19
Advertisement
Table of Contents
