Removing A Gbic Optical Port; Bnc Ports - Siemens RUGGEDCOM RSG2100 Installation Manual

Chapter 3
Communication Ports
Section 3.4.2

Removing a GBIC Optical Port

To remove an GBIC optical port, do the following:
CAUTION!
Electrical hazard – risk of damage to equipment. Make sure all electrostatic energy is dissipated before
performing installing or removing components from the device. An electrostatic discharge (ESD) can
cause serious damage to the component once it is outside the chassis.
1. Make sure all potential electrostatic build-up has been properly discharged to prevent electrostatic
discharges (ESD). This can be accomplished by wearing an ESD wrist strap or by touching Earth or the
chassis ground.
2. Disconnect the cable from the port.
3. Squeeze the latches on either side of the port and pull it from the module.
Figure 35: Removing a GBIC Optical Port
1. GBIC Optical Port Module
4. Store the port in an ESD-safe bag or other suitable ESD-safe environment, free from moisture and stored at
the proper temperature (-40 to 85 °C or -40 to 185 °F).
5. Insert a plug in the empty port opening to prevent the ingress of dust and dirt.
Section 3.5

BNC Ports

The following BNC ports are available on the PTP module:
26
2. GBIC Optical Port 3. Locking Latch
1
2
3
RUGGEDCOM RSG2100
Installation Guide
Removing a GBIC Optical Port