Flat Tire - Mercedes-Benz SL 2018 Operator's Manual

Table of Contents

Advertisement

Tire-change tool kit
The tire-change tool kit can be found in the
stowage well under the trunk floor (
Bag containing the tire-changing tools
:
Bag : with the tire-changing tools contains:
jack
R
lug wrench
R
alignment bolt
R
wheel chock
R
gloves
R
Depending on the equipment, tools required for
a wheel change, such as a jack or a lug wrench,
are not available in all vehicles. Tools approved
for your vehicle are available at a qualified spe-
cialist workshop.

Flat tire

Preparing the vehicle
Your vehicle may be equipped with:
tires with run-flat characteristics
R
(MOExtended tires) (
Vehicle preparation is not necessary on vehi-
cles with MOExtended tires.
a TIREFIT kit (
page 270)
R
Y
Vehicles with the Mercedes-Benz emer-
gency call system: in the event of a flat tire, you
can contact the Mercedes-Benz emergency call
system customer center.
Vehicles equipped with MOExtended tires are
not equipped with a TIREFIT kit at the factory. It
is therefore recommended that you additionally
equip your vehicle with a TIREFIT kit if you mount
tires that do not feature run-flat characteristics,
e.g. winter tires. A TIREFIT kit may be obtained
from a qualified specialist workshop.
page 245).
Y
page 271)
Y
Information on changing and mounting wheels
(
page 303).
Y
Stop the vehicle on solid, non-slippery and
X
level ground, as far away as possible from
traffic.
Switch on the hazard warning lamps.
X
Secure the vehicle against rolling away
X
(
page 142).
Y
If possible, bring the front wheels into the
X
straight-ahead position.
Switch off the engine.
X
Vehicles without KEYLESS-GO: remove the
X
SmartKey from the ignition lock.
Vehicles with KEYLESS-GO: open the driv-
X
er's door.
The vehicle electronics now have status 0.
This is the same as the SmartKey having been
removed.
Vehicles with KEYLESS-GO: remove the
X
Start/Stop button from the ignition lock
(
page 122).
Y
Make sure that the passengers are not endan-
X
gered as they do so. Make sure that no one is
near the danger area while a wheel is being
changed. Anyone who is not directly assisting
in the wheel change should, for example,
stand behind the barrier.
Get out of the vehicle. Pay attention to traffic
X
conditions when doing so.
Close the driver's door.
X
MOExtended tires (tires with run-flat
properties)
General notes
With MOExtended tires (tires with run flat char-
acteristics), you can continue to drive your vehi-
cle even if there is a total loss of pressure in one
or more tires. The affected tire must not show
any clearly visible damage.
You can recognize a MOExtended tire by the
MOExtended marking which appears on the
sidewall of the tire. You will find this marking
next to the tire size designation, the load-bear-
ing capacity and the speed index (
MOExtended tires may only be used in conjunc-
tion with an active tire pressure monitor.
Flat tire
271
page 298).
Y

Advertisement

Table of Contents
loading

Table of Contents