Table of Contents
Advertisement
Features
256
Setting the compass
North America zone map
South America zone map
Set your location using the zone maps.
X
Push a round pen into opening =
X
(
page 255) for approximately three sec-
Y
onds.
The zone currently selected appears in com-
pass display ; (
To select the zone: push a round pen into
X
opening = (
Y
zone is selected.
If, after a few seconds, the display in compass
display ; (
Y
the zone has been selected.
page 255).
Y
page 255) until the desired
page 255) changes direction,
Calibrating the compass
Make sure that there is sufficient space for
X
you to drive in a circle without impeding traf-
fic.
In order to calibrate the compass correctly, do
the following:
calibrate the compass in the open and not in
R
the vicinity of steel structures or high-voltage
transmission lines.
switch off electrical consumers such as the
R
climate control, windshield wipers or rear win-
dow defroster.
close all doors and the trunk lid.
R
Switch on the ignition.
X
Push a round pen into opening =
X
(
page 255) for approximately six seconds,
Y
until symbol
C
is shown in compass display ;
(
page 255).
Y
Drive your vehicle in a full circle at approx-
X
imately 3 mph (5 km/h) to 6 mph (10 km/h).
When the calibration has successfully been
completed, the current direction is shown in
compass display ; (
Floormats
G
WARNING
Objects in the driver's footwell may restrict
the clearance around the pedals or block a
depressed pedal. This jeopardizes the oper-
ating and road safety of the vehicle. There is a
risk of an accident.
Stow all objects securely in the vehicle so that
they do not get into the driver's footwell.
When using floormats or carpets, make sure
that they are properly secured so that they do
not slip or obstruct the pedals. Do not place
several floormats or carpets on top of one
another.
page 255).
Y
Advertisement
Table of Contents
