Table of Contents
Advertisement
Care
264
!
Make sure that:
the side windows and the roof are com-
R
pletely closed
the climate control blower is switched off
R
the windshield wiper switch is at position 0
R
The vehicle could otherwise be damaged.
You can clean the vehicle at an automatic car
wash from the very start.
Preferably clean the vehicle at automatic car
washes that use textile washing elements with-
out brushes. This prevents fine scratches from
forming on the paintwork and film.
If the vehicle is very dirty, pre-wash it before
cleaning it in an automatic car wash.
After using an automatic car wash, wipe off wax
from the windshield and the wiper blades. This
will prevent smears and reduce wiping noises
caused by residue on the windshield.
i
Vehicles with decorative film: select a wash
program without hot wax at the automatic car
wash.
Washing by hand
In some countries, washing by hand is only
allowed at specially equipped washing bays.
Observe the legal requirements in each country.
Do not use hot water and do not wash the
X
vehicle in direct sunlight.
Use a soft sponge to clean.
X
Use a mild cleaning agent, such as a car
X
shampoo approved by Mercedes-Benz.
Thoroughly hose down the vehicle with a gen-
X
tle jet of water.
Do not point the water jet directly towards the
X
air inlet or the edges of decorative foils.
Use plenty of water and rinse out the sponge
X
frequently.
Rinse the vehicle with clean water and dry
X
thoroughly with a chamois.
Do not let the cleaning agent dry on the paint-
X
work or the decorative foils.
Carefully remove all deposits of road salt as
soon as possible when driving in winter.
Power washers
G
WARNING
The water jet from a circular jet nozzle (dirt
blasters) can cause invisible exterior damage
to the tires or chassis components. Compo-
nents damaged in this way may fail unexpect-
edly. There is a risk of an accident.
Do not use power washers with circular jet
nozzles to clean the vehicle. Have damaged
tires or chassis components replaced imme-
diately.
!
Vehicles with decorative foil: parts of your
vehicle are covered with decorative foil. Main-
tain a distance of at least 27.5 in (70 cm)
between the foil-wrapped parts of the vehicle
and the nozzle of the high pressure cleaner.
Information about the correct distance is
available from the equipment manufacturer.
Move the power washer nozzle around when
cleaning your vehicle.
The water temperature of the high-pressure
cleaner must not exceed 140 °F (60 °C).
!
Always maintain a distance of at least
11.8 in (30 cm) between the vehicle and the
power washer nozzle. Information about the
correct distance is available from the equip-
ment manufacturer.
Move the power washer nozzle around when
cleaning your vehicle.
Do not aim directly at any of the following:
tires
R
door gaps, roof gaps, joints, etc.
R
electrical components
R
battery
R
plug-type couplings
R
lights
R
seals
R
trim
R
ventilation slots
R
Damaged seals or electrical components can
lead to leaks or failures.
Advertisement
Table of Contents
