Table of Contents
Advertisement
*Failure to properly clean your stove can cause poor performance and possibly a burn back!*
Disposal of Ashes – Ashes should be placed in a metal container with a tight fitting lid.
The closed container of ashes should be placed on a noncombustible floor or on the
ground, well away from all combustible materials, pending final disposal. If the ashes are
disposed of by burial in soil or otherwise locally dispersed, they should be retained in the
closed container until all cinders have been thoroughly cooled.
Important Notes
As with any maintenance concerning this unit, be
sure the unit is "OFF" and has completed the
Shut‐Down cycle BEFORE beginning.
Be aware that metal parts in the firebox can
remain HOT long after the fire has gone out and
EVEN after the Shut‐Down cycle is complete.
Always use extreme caution when handling
potentially hot stove parts, even if you think they
should be cold.
Ashes should only be removed when the stove
has been shutdown and has been allowed to cool
thoroughly. Hot embers can remain under ashes
long after the fire has gone out, so always be
extra careful when handling any ashes from this
(or any) stove.
Different pellets will generate varying amounts of ash and burn pot deposits. Carefully monitor the ash
build up in the stove when first operating the unit, as well as whenever a different brand of pellets is
burned.
While the amount of ashes generated by this unit is not excessive compared to a traditional log‐burning
woodstove, keeping the unit clean and free of ash is ESSENTIAL for peak performance and maximum
efficiency. Ash build‐up hampers airflow, reduces efficiency, and can cause a smoke back.
England's Stove Works® is not responsible for any damages incurred due to a poorly maintained and/or
dirty stove. This pellet stove is a highly efficient machine and, as such, requires sufficient maintenance to
keep it operating at its peak.
Ash Removal and Disposal (at least twice per week)
Press the "Off" button and allow the stove to complete the shutdown cycle and cool completely.
A long‐handled screwdriver or long‐handled putty knife can be used to scrape any build‐up or crust into the
burn pot area. This can then be pushed left or right into the ash storage area.
Remove the ashes with a scoop. Follow the "Disposal of Ashes" instructions listed above (under Daily
Maintenance).
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
DAILY MAINTENANCE
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
Burn Pot
34
Baffle Plate
Wear Plate
Advertisement
Table of Contents
