Table of Contents
Advertisement
CONTROL BOARD SETTINGS – TOP MOUNT BOARD
Please Note: The following section gives instructions for stove models with the Top
Mount control board (where the control board is mounted on the top of the stove,
behind the hopper).
Please see the section of the manual "Control Board Settings – Side Mount Board"
for instructions pertaining to stoves with a Side Mount control board.
Manual/Automatic Mode
Automatic Mode
Your stove will arrive from the factory programmed in automatic mode. First, make sure the thermocouple
wire is resting loosely outside the back of the stove (so that it is reading the air temperature) in a safe location
where it can't be damaged. It should not rest directly on the floor, or it will pick up the floor temperature. The
thermocouple wire is the "room temperature heat sensor" whereby the control board will read the room
temperature.
In this mode, after initiating the startup sequence, you select the desired room temperature (ranging from 60
to 90 degrees F) by pressing the Up or Down arrows, and the stove will operate the auger feed and blower
speed according to the temperature you have selected.
The stove will heat to whichever temperature you set the stove at until the call for heat leaves, at which point
the stove will adjust itself higher or lower as needed, depending on the room temperature readings supplied
by the room heat sensor.
To turn the stove off completely, press the OFF button on the control board.
Manual Mode
Your stove can be changed to run in manual mode, if desired. In manual mode, after pressing the ON button,
the stove will run continuously, based on desired heat range and blower speed settings. The heat range
settings will be 1 through 9 (the Up arrow will increase the heat range and the Down arrow will decrease the
heat range), with 1 being the lowest auger feed setting and 9 being the highest. The blower speed range will
match the heat range that you have set.
Since the stove runs continuously at the selected heat range in this mode, it is generally recommended for
stoves installed in less‐insulated areas of the home and extremely cold climate regions.
To turn the stove off completely, press the OFF button on the control board.
21
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
Advertisement
Table of Contents
